Welch Allyn SCANTEAM 6920 Spécifications télécharger pdf (Page 46)

2-23

FMT 3000 Hardware Reference Manual - Installation

Connecting the Unit’s Standard Communication

Interfaces

This section discusses connection of the unit’s general purpose serial communications (RS-

232) interfaces and the 10BaseT Ethernet interface. Connection and use of data collection

devices to appropriate interfaces is discussed in Chapter 3, Option Installation and

Operation.

To communicate using these interfaces, install and conﬁgure communications software and

supply cabling. To operate any of the general purpose serial ports (COM1 and COM2), the

serial communications software must be loaded on the unit’s system PCMCIA memory card

or loaded from a network drive. To use the unit over a 10BaseT Ethernet network, the

appropriate network driver software must be installed on the unit’s system memory card and

any appropriate applications software. Disks containing the basic network software are

shipped with the unit. Network software is discussed in the FMT 3000 Software Manual in

Chapter 3, Networking.

To initially load network software on the unit’s system memory card, remove the card and

install it in another computer equipped with a PC Card (PCMCIA) slot and a 3.5” ﬂoppy

diskette drive to transfer the ﬁles. This is the easiest and recommended method.

Alternatively, if it is a PC/104 style drive controller and 3.5” ﬂoppy drive, run the Standard

CMOS Setup (to conﬁgure the system to recognize the ﬂoppy) and transfer the ﬁles to

memory card. Discussion of PC Card software (which is installed on the system memory

card) is found in Chapter 6, PC Card Slots, in the FMT 3000 Software Manual.

Connecting the Unit’s Serial Ports

The unit has two general purpose 9-pin serial ports, COM1 and COM2. The standard DB9-

pin male connector for COM1 is located inside the unit’s case as shown below. COM2’s

standard DB9-pin male connector is located at the recessed area at the front of the unit.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 123 124

Pas de commentaire

Welch Allyn SCANTEAM 6920 Spécifications Page 46