Welch-allyn 777 34 Wall Panel Instructions - Installation Guid Manuel d'utilisateur télécharger pdf

Installation

Instructions

34" Integrated Panel With

Diagnostic System

Unpacking Notes

• Concealed Damage. If there should be damage of

such nature that it could not be detected until the

goods were unpacked, have the Transportation

Company's Agent come AT ONCE and inspect them.

Require them to give you a "concealed" bad order

report stating the condition of the goods when exam-

ined. It is their duty to do this and you should INSIST

upon it.

• If the Above Instructions are Complied With, we

shall cheerfully render all possible assistance in

establishing claims against the Transportation Com-

pany for loss and damage in transit.

• We Do Not Accept Goods Returned For Credit,

Exchange, Repairs, or for any other reason, unless

you have first communicated with us and secured our

written permission.

Installation

NOTE

The Integrated Panel is mounted to the wall using steel

mounting bracket (provided with the unit). Wall anchors

and drywall screws are also provided to secure the

mounting bracket to the wall. Figures 1 and 2 are

suggested mounting configurations and locations only.

1. Using the customer or room layout drawing, determine

where the Integrated Panel will be located. See Figure

1 for the suggested room layout.

2. Measure and mark the mounting locations of the

mounting bracket on the wall. See Figure 2.

3. Locate and mark the location of studs in reference to

mounting bracket; an electronic stud finder may be

useful.

NOTE

This note applies to steps 4 thru 6. When securing

mounting brackets to a wall with metal studs, use sheet

metal screws in place of drywall screws and when

securing mounting brackets to a masonry / concrete block

wall, use masonry screws in place of drywall screws and

wall anchors.

4. Place the mounting bracket in position on wall and

mark the locations of all fasteners. Remove the

mounting bracket and drill a 3/8 in. hole where all wall

anchors are to be used; four holes per mounting

bracket if a wall stud is not located and three holes per

mounting bracket if a wall stud is located.

5. Install a wall anchor in each hole. Install a screw in

each wall anchor and tighten far enough to secure the

wall anchor in place. Then, remove all screws from the

wall anchors.

6. Attach mounting brackets to the wall using wall anchor

screws. Level the mounting bracket before securing to

the wall.

7. Test the mounting bracket for strength.

8. Mount the instruments to the Integrated Panel as

follows using Figure 3, 4, 5, 6 or 7 to properly position

the instruments:

Position the Aneroid Blood Pressure Unit on the single

screw provided and then secure top of unit in place

using two additional screws provided. Install (hang)

the remaining instrument assemblies on the pre-

installed mounting screws.

Position the Sure Temp Plus on the two screws

provided and then secure the unit in place using two

additional screws provided.

9. Lift the Integrated Panel onto their mounting brackets.

Sheet 1 of 2

FIGURE 1. SUGGESTED ROOM LAYOUT

10'-0"

STOOL

8'-0"

DRESSING

NOOK

CASEWORK

MA318401

SIDE

CHAIR

INTEGRATED

PANEL

EXAM

TABLE

1 2

Résumé du contenu

Page 1 - Instructions

InstallationInstructions34" Integrated Panel With Diagnostic SystemUnpacking Notes• Concealed Damage. If there should be dam

Page 2 - PANEL

MA738100iSpot Vital Signs LXiMA417700Aneroid BloodPressure UnitWall Transformer ForOtoscope/OphthalmoscopeKleenSpecDispenser102040608010012014016018

Commentaires sur ces manuels

Pas de commentaire

Welch-allyn 777 34 Wall Panel Instructions - Installation Guid Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Welch-allyn 777 34 Wall Panel Instructions - Installation Guid. Welch Allyn 777 34 Wall Panel Instructions - Installation Guide User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Welch-allyn 777 34 Wall Panel Instructions - Installation Guid