Welch Allyn PROPAQ CS Manuel de service télécharger pdf (Page 100)

96 Repair procedures Welch Allyn Propaq CS Vital Signs Monitor

Installing the printer

1. Lay the Chassis on its back

2. Completely open the paper door.

3. Slide the Printer Assembly into the guides as shown below, making sure that after the

door latch mechanism clears the chassis you rotate it clockwise to engage the printer

door pin. (Also see the figure above.)

printer assy in stallation

4. Carefully close and open the door a couple times to check that the door pin and latch

mechanism function without binding.

5. Connect the battery cable and printer cable to the Printer Main Board. It is important

to properly dress the cables as shown below.

‘printer cable dress

6. Connect the button cable to the front of the Printer Main Board.

7. Install the Expansion Module front panel, close the Expansion Module, and reattach it

to the monitor.

Caution As you install the Printer Assembly, rotate the printer door latch

mechansim out of the way so it clears the Chassis. The Printer Assembly fits

snugly, but should not require much force to slide it in place.

Guides

0696-51

Battery

Cable

(Dress tight

against plastic)

Battery

Cable

Printer

Cable

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 141 142

Pas de commentaire

Welch Allyn PROPAQ CS Manuel de service Page 100